Document Actions
Split Arm Tippling Paper Roll Clamps : Technical drawing
The 180° Rotating, 90° Tippling Split Arm Paper Roll Clamp can handle 1 or 2 different diameter rolls either in the vertical or horizontal position. The thin profile arms prevent damage to the rolls and allow compact stacking and retrieving without any problems.
- Additional hydraulics required
> three for clamping, rotating and tippling functions - An adjustable relief valve protects
the unit from pressures above 150 bar - Designs of short arm:
Type with letter index B = adjustable in any position - Standard pads: cast pads with high-friction surface
- NOTE: For lifting horizontal rolls a 5°-mast tilt is required.
If less tilt, please contact MEYER. - Hydraulic flow:
3-3622 - 35H-B - 45 Ltr./min.
3-3638 - 45H-B - 60 Ltr./min.
- Further facings and dimension of pads
- Single pads for both arms
- Hydraulic extension
(Further additional hydraulic or solenoid required) - Same length clamp arms
for handling small rolls in tippled position - Solenoid valve
- Solenoid valve control kit
(cable drum, push button, relay) - Further options
(see also accessories)
[ Split Arm Tippling Paper Roll Clamps
]
90° tippling, 180° rotating, split long arms
Technical drawing
Residual capacity calculation: click on the line to start the calculation for this specific type