Document Actions
Tissue Roll Clamp
: Technical drawing
The Meyer 360° rotating tissue roll clamp has large contact pads and was developed especially for handling horizontal or vertical large diameter tissue rolls. Large contact pads and thin profile arms prevent damage to rolls and allow for compact stacking and retrieving. The clamp uses the proven MEYER rotator with direct worm / ring gear drive and clutch brake system. The 360° rotation prevents roll edge damage when placing rolls down onto surfaces that are not level.
- Additional hydraulics required
> two - An adjustable pressure relief valve is included
- Short arm: Type with the letter A = adjustable at 45° only / B =
adjustable in any position - Tissue pads without facing with double rounded edges
5° mast tilt is required for the handling of horizontal rolls. - Truck pressure must be 150 bar. Lower pressures can reduce
clamp capacity. - Hydraulic flow:
5-3501F - 20 Ltr./min. 5-3503N - 25 Ltr./min. 5-3504N/05N - 30 Ltr./min. 5-3507N/08N - 50 Ltr./min. 5-3509N/F / 10N - 60 Ltr./min.
- Other capacities and roll diameters
- Separate, built-on sideshift
(Further additional hydraulic or solenoid required)
- ISO II, +/- 100 mm
- ISO III, +/- 100 mm
- ISO IV, +/- 100 mm - Solenoid valve
- Solenoid valve control kit
(cable drum, push button, relay) - Quick disconnect lower hooks
- ISO II
- ISO III - Setting of rotation range 180°
- Other pad facing
[ Tissue Roll Clamp
]
360° rotating
Technical drawing
Residual capacity calculation: click on the line to start the calculation for this specific type