Document Actions
Paper Roll Clamp
: Technical drawing
The MEYER 360° rotating paper roll clamp is suitable for lifting horizontal or vertical paper rolls in a large range of diameters. The split arm design enables 2 rolls of different diameters to be lifted. The thin profile contact pad arms prevent damage to the rolls and allow for compact stacking and retrieving. The clamp uses the proven MEYER rotator with direct worm/ring gear drive and clutch brake system. The 360° rotation prevents damage when placing rolls down onto surfaces that are not level.
- Additional hydraulics required
> two - An adjustable pressure relief valve is included
Standard pad facings metal grain - Mast tilt required for the handling of horizontal rolls:
- Generation N: 5°, Generation F: 3,5°
- Short arm: Type A = adjustable at 45° only / B = adjustable in any
position - Truck pressure must be 150 bar. Lower pressures can reduce clamp
capacity. - Hydraulic flow:
5-2601F, 02F - 20 Ltr./min. 5-2603N/F - 25 Ltr./min. 5-2604N/F, 05N/F - 30 Ltr./min. 5-2606N/F - 40 Ltr./min. 5-2607N/F, 08N/F, 09F - 50 Ltr./min. 5-2610N/F, 12N/F - 60 Ltr./min.
- Other capacities and roll diameters
- Separate, built-on sideshift
(Further additional hydraulic or solenoid required)
- ISO II, +/- 100 mm
- ISO III, +/- 100 mm
- ISO IV, +/- 100 mm - Solenoid valve
- Solenoid valve control kit
(cable drum, push button, relay) - Quick disconnect lower hooks
- ISO II
- ISO III - Setting of rotation range 180°
- Pad facing
- Rubber 10 mm
- Rubber 20 mm
- Diamond shaped rubber 10 mm
- Polyurethane
- Metal grit H30/24/16
- Chequer facing
- More on request - Additional wear plate for short arm
(optional extra)
[ Paper Roll Clamp
]
360° rotating, split arm
Technical drawing
Residual capacity calculation: click on the line to start the calculation for this specific type